Электронный архив
Донецкого национального технического университета (г.Донецк)
Electronic archive of Donetsk national technical university (Donetsk)
 

eaDonNTU, Donetsk >
Научные труды ДонНТУ >
Серія: Обчислювальна техніка та автоматизація >
Випуск 2 (27) >

Пожалуйста, используйте этот идентификатор, чтобы цитировать или ссылаться на этот ресурс: http://ea.donntu.ru/handle/123456789/29194

Название: Автоматизация процесса химической очистки воды ТЭС
Другие названия: Автоматизація процесу хімічного очищення води ТЕС
Automating the process of chemical water treatment thermal power plant
Авторы: Федюн, Роман Валерьевич
Табаленкова, Т.В.
Попов, В.А.
Попов, В.О.
Fedyun, R.
Tabalenkova, T.
Popov, V.
Ключевые слова: chemical water treatment
pH-setting
temperature of feed water
automatic control system
PID controller
mathematical modeling
химическая очистка воды
рН-параметр
хімічне очищення води
рН- параметр
температура питательной воды
температура живильної води
система автоматического управления
система автоматичного управління
ПИД-регулятор
ПІД- регулятор
математическое моделирование
математичне моделювання
Дата публикации: 2014
Издатель: ДонНТУ
Библиографическое описание: Наукові праці Донецького національного технічного університету. Серія: Обчислювальна техніка та автоматизація. №2 (27) / ДВНЗ "ДонНТУ" ; редкол.: О.А. Мінаєв та ін. - Донецьк : ДонНТУ, 2014. - 230с.
Аннотация: Выполнен анализ системы химической очистки как объекта автоматического управления. Поскольку процесс химической очистки воды представляет собой совокупность нескольких процессов, то система автоматического управления предоставлена двумя контурами управления технологическими параметрами. Главным регулируемым параметром является значение рН в осветлителе, дополнительным, который представлен в виде возмущения, температура питательной воды в теплообменнике. Разработаны математические модели предложенных контуров САУ химической очистки воды. Выбраны регуляторы и определены их настроечные параметры. Выполненное моделирование динамических процессов в САУ подтвердило эффективность предложенных законов управления.
Описание: Chemical water treatment complex process, which is a set of subsystems,which consist of heat exchangers, fixtures, pipes, pumps, valves and motors that drive the system. Task of chemical water treatment is trouble-free operation of all components of the installation provided quality water purification and waste minimization, at the lowest cost her the greatest simplicity and reliability of a given water treatment system. Analysis of this question showed that the process of chemical water treatment is a multidimensional object, the effective functioning of which is impossible without modern automation systems. This paper examines two interrelated systems: stabilization of water temperature in the heat exchanger, the stabilization of pH setting in an illuminator. Were obtained mathematical descriptions of each circuit and developed a mathematical model of the chemical treatment of water. PH - stabilization parameter in the illuminator is a complex system, which is implemented by means of the ratio regulator. For this system were needed two controls: for the external control loop was selected PID and internal PD controller whose settings were based on the recommended values and by experimental verification. Stabilization of the temperature in the heat exchanger was presented as a perturbation for the first system. For this circuit was used PD controller. Was simulated resulting mathematical model of the chemical treatment of water. Analysis of the results showed satisfactory performance transients above. Simulation results, the following conclusions: the time during which the temperature parameter and pH- parameter set, match the technical task, the value of overshoot does not exceed 5 %, set to meet the required, set the value of the error signal to zero and the disturbance leads to small admissible deviations that are recovered for allowable time. Regulatory body is correct and effective, since the maximum valve opening angle is half of the maximum possible nominal values. Thus, the proposed regulation laws with those obtained tuning parameters showed quite a smooth process with sufficient speed and quality indicators ACS as desired.
URI: http://ea.donntu.org/handle/123456789/29194
Располагается в коллекциях:Випуск 2 (27)

Файлы этого ресурса:

Файл Описание РазмерФормат
Fedyun_2.pdf651.83 kBAdobe PDFПросмотреть/Открыть

Все ресурсы в архиве электронных ресурсов защищены авторским правом, все права сохранены.